Land-Based-Products
Flame Arrester
Flame Arrester is used for preventing of flame transmission any more when an explosion is occurred inside of the piping which is full of explosive mixed gas.
It's known as inflammability prevention equipment, reverse flame prevention equipment from old day.
It's limits so as not to be occurred extension of damage when explosion is occurred in chemical equipment or the progress of work.
In addition to, if safety equipment of this kind is installed you can prevent from big calamities occasionally.
Function of Flame Arrester is to stop of flame when it's extraordinary.
It need practically not to disturb flowage of gas of piping inside in common operation condition.
There is several methods of principle to prevent extension of flame method by stick of water, interception of a pipe conduit by detection of flame or scattering of inactivity material but there's some practical problems as easiness of usage, reliance, a response, economical efficiency. Also, there are water seals, packed beds, velocity-type arresting device.
It's known as inflammability prevention equipment, reverse flame prevention equipment from old day.
It's limits so as not to be occurred extension of damage when explosion is occurred in chemical equipment or the progress of work.
In addition to, if safety equipment of this kind is installed you can prevent from big calamities occasionally.
Function of Flame Arrester is to stop of flame when it's extraordinary.
It need practically not to disturb flowage of gas of piping inside in common operation condition.
There is several methods of principle to prevent extension of flame method by stick of water, interception of a pipe conduit by detection of flame or scattering of inactivity material but there's some practical problems as easiness of usage, reliance, a response, economical efficiency. Also, there are water seals, packed beds, velocity-type arresting device.
Benefits
• Meet USCG, IMO MSC/Circ,677 & EN ISO 16852 requirements
• Designed for Explosion proof
• Maximum Capacity & Minimum Pressure drop
• Quick & Easy removable element
• Very easy cleaning & maintenance
• Vertical installation
• High quality corrosion & chemical resistance
• Meet USCG, IMO MSC/Circ,677 & EN ISO 16852 requirements
• Designed for Explosion proof
• Maximum Capacity & Minimum Pressure drop
• Quick & Easy removable element
• Very easy cleaning & maintenance
• Vertical installation
• High quality corrosion & chemical resistance
INTRODUCTION
The KSFE flame arrester are designed, manufactured and tested according to BS 7244 (British Standard Specification) code and EN ISO 16852.
The units allow free venting in combination with flame protection for vertical vent application.
Housing construction are Aluminum, Cast Iron, Cast Steel, 304SS and 316LSS.
Size are from 20mm through to 300mm.
Cast iron and cast steel units are epoxy coated both inside and outside.
The Flame Arrester of Model KSFE is designed, manufactured, tested according to BS 7244 and EN ISO 16852.
Installed in the end of nozzle of the several kinds of the flammable low pressure storage tank (the ignition point below 65 deg C) with easy coupling, it is the explosion proof and deflagration proof which blocks the influx of flame ignited externally into the tank.
The units allow free venting in combination with flame protection for vertical vent application.
Housing construction are Aluminum, Cast Iron, Cast Steel, 304SS and 316LSS.
Size are from 20mm through to 300mm.
Cast iron and cast steel units are epoxy coated both inside and outside.
The Flame Arrester of Model KSFE is designed, manufactured, tested according to BS 7244 and EN ISO 16852.
Installed in the end of nozzle of the several kinds of the flammable low pressure storage tank (the ignition point below 65 deg C) with easy coupling, it is the explosion proof and deflagration proof which blocks the influx of flame ignited externally into the tank.
| DEFLAGRATION PROOF TYPE | |
|---|---|
| MATERIAL | AL / C.S / S.S |
| SIZE | 2 |
| GAS GROUP | IIA, IIB |